28. März 2024, 23:36:29 Uhr

komme nicht ins Bios

Begonnen von Hawk, 28. April 2007, 18:38:14 Uhr

⏪ vorheriges - nächstes ⏩

0 Mitglieder und 1 Gast betrachten dieses Thema.

Hawk

Hallo Leute,

ich habe hier ein Toshiba Portege m100. Wenn ich das Ding starte kommt keine Meldung wie ich ins Bios reinkomme.
Normalerweise bei Notebooks mit Alt+F2 oder del. Das Ding hat einen Intel Boot Agenten drauf.
Habe schon ein LowLevel format gemacht um den Intel Boot Agent runter zu schmeißen. Leider vergebens.

Meine Frage: Wie komme ich ins Bios von diesem Notebook und wie kann ich den Intel Boot Agenten deaktivieren?

Grüße

Hawk

tyco

06. Mai 2007, 09:53:34 Uhr #1 Letzte Bearbeitung: 06. Mai 2007, 10:19:51 Uhr von tyco
Zitat von: Hawk am 28. April 2007, 18:38:14 Uhr

Meine Frage: Wie komme ich ins Bios von diesem Notebook und wie kann ich den Intel Boot Agenten deaktivieren?


Laut Handbuch zum Portégé M100 kommst Du mit der Funktionstaste F1 ins Bios-Setup.

Um den Intel Boot Agenten zu deaktivieren schau mal hier:

How Do I Turn the Boot Agent Off or Prevent It from Running? (http://www.intel.com/support/network/sb/cs-008018.htm)

ZitierenTo prevent the Boot Agent from executing, enter your systems BIOS configuration and find the boot device order settings. Move the boot agent further down the list, preferably after the hard drive or whatever device you prefer to boot from.

The Boot Agent will initialize during the system startup, even if it is not the first boot device. During the time the initialization screen is displayed, you can press Control-S to configure the Boot Agent's internal settings.

To prevent the Boot Agent from even initializing, you can turn it off completely. The Intel® Boot Agent can be completely turned off by using the IBAUtil.exe DOS utility found in the PROBOOT archive, using the command line IBAUTIL - FD (flashdisable).

The Boot Agent is enabled by default on desktop adapters, and disabled by default on server adapters. To enable the Boot Agent on server adapters, use the IBAUTIL utility with the command line IBAUTIL -FE to enable the flash.

Bitte keine Supportanfragen per PM stellen.